![]() They provide pretty complete descriptions of each option, and are themselves the source for most of the information presented here. The most authoritative source on configuration details will always be the configuration files themselves. Most settings will come over without changes, then you can review any tricky changes that remain. To migrate your settings to a new Configuration you can use tools like Notepad++ or Winmerge to compare old configurations with the newer (default) configurations and copy settings over on a change-by-change basis. As part of the build process, Marlin will check for outdated options and show error messages that explain exactly what needs to be changed. To use configurations from an earlier version of Marlin, first try dropping them into the newer Marlin, updating CONFIGURATION_H_VERSION and CONFIGURATION_ADV_H_VERSION, and building the firmware. #define THIS_IS_DISABLED // this switch is disabled #define OPTION_VALUE 22 // this setting is "22" #define THIS_IS_ENABLED // this switch is enabled Settings can be enabled, disabled, and assigned values using C preprocessor syntax like so: A build of Marlin can range from 50K to over 230K in size. This results in the smallest possible binary. ![]() This allows Marlin to leverage the C++ preprocessor and include only the code and data needed for the enabled options. Marlin is configured using C++ compiler directives. Hundreds of user-donated configurations are posted at the Configurations repository to get you started. Simply edit or replace these files, then build and upload Marlin to the board. D2) // Connect pin B (the other outer one) to another. Connect pin A (one of the outer ones) to a pin that can generate interrupts (eg. ![]() h files contain all of Marlin’s build-time configuration options. I have a page about rotary encoders - in that I show how you can detect encoder changes (and direction) using one interrupt pin and another pin, like this: // Wiring: Connect common pin of encoder to ground. See the Configuration with INI page for more information. config.ini may be included to modify the configuration at the start of a PlatformIO build.Configuration_adv.h contains more detailed customization options, add-ons, experimental features, and other esoteric settings. Watch the Video Step 1: What You Will Need Arduino UNO (or any other board) 2X Stepper motor 28byj-48 & stepper motor driver board Rotary Encoder Sensor Jumper. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |